Page Areas:



Current Submenu:

Additional Information:

Innovative Metrology 2017

Rückblick: Innovation Messtechnik 2015

Where to find us

Plan of our location where to find us.

HF-Building, Northern Wing, Ground-Floor ...  more of Where to find us (Titel)


Position Indication:

Content

Contactless Resonant Coupled Inductive Absolute Position Sensor for Linear and Angular Measurement Applications

Dipl.-Ing. Dr. Bernhard Aschenbrenner

   

Supervisory Committee:

Univ.-Prof. Dipl.-Ing. Dr. Bernhard Zagar
Univ.-Prof. Dipl.-Ing. Dr. Oszkar Biro

Final exam:

July 14, 2015

The objective of this research was to develop a novel absolute angle sensor technology which is applicable for through-shaft applications.
The sensor has to be narrow enough to be integrated in a ball bearing cap.
SKF Österreich AG approached the Austrian Center of Competence in Mechatronics (ACCM) to conduct this research.
The sensor works on principles similar to contactless resolvers.
It bases on printed circuit board technologies and its working principles rely on mutual inductive coupling.
Thus, the sensor only consists of a planar excitation coil and position sensing coils formed by conductive tracks on a narrow antenna PCB, which is illustrated in Figure 1, and a detached target PCB which is a passive resonant serial RLC circuit illustrated in Figure 2.
Furthermore, this position sensor is suitable for rough industrial environments, offers a high inherent resolution, can measure target position over a wide measurement range, and can potentially measure multiple target locations simultaneously.
The basic position resolution is improved by adding two additional finer pitched position sensing coils.
The sensor provides amplitude modulated or phase modulated target position dependent output signals.
Furthermore, mathematical models for both cases are derived and discussed in detail.
The use of coupled resonances enables to overcome the weak coupling between the excitation coil and the target coil.
A Cramer-Rao lower bound analysis was performed to evaluate the minimum achievable uncertainty of the position reading.

The amplitude modulated positioning sensing coils signals were demodulated and transformed to a discrete time representation by utilizing bandpass sampling. A novel absolute angle measurement system for large trough shaft applications was introduced and discussed in detail. A notable advantage of this angle measurement principle is that the axial antenna PCB arrangement allows using the same antenna PCB for different shaft diameters. Furthermore, a test-bench was designed to evaluate the measurement performance of the developed angle measurement system. The test bench measurement results of an inductive large diameter through-shaft angel measurement sensor were presented and analyzed in detail.

Figure 1: Antenna PCB contains the single rectangular excitation coil and two pairs of sine-shaped position sensing coils with two different cycle lengths.  These enable both absolute and precise position measurements.

Figure 1: Antenna PCB contains the single rectangular excitation coil and two pairs of sine-shaped position sensing coils with two different cycle lengths. These enable both absolute and precise position measurements.

Figure 1:  Passive RLC circuit with the rectangular self inductance and the soldering pads for the discrete capacitances.  On the four layer PCB the rectangular self inductance is formed by five loops a layer, which consists of a set of straight conductive tracks.

Figure 2: Passive RLC circuit with the rectangular self inductance and the soldering pads for the discrete capacitances.
On the four layer PCB the rectangular self inductance is formed by five loops a layer, which consists of a set of straight conductive tracks.

Keywords: Inductive Position Sensor, Coupled Resonances, Through-Shaft, Bandpass Sampling, Cramer-Rao Lower Bound, Absolute Position Measurement, Printed Circuits

The circulation of the project work is restricted from June 13th, 2015, for a period of 5 years.